DIYRE G BUS Bedieningshandleiding - Pagina 4

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} DIYRE G BUS. DIYRE G BUS 13 pagina's. Stereo vca compressor

Front Panel Description

THRESHOLD

: Sets the gain level at which compression starts. The clockwise position is maximum (least sensitive),

turn counterclockwise to lower the threshold.

ATTACK

: Sets the attack time of the compressor, measured in milliseconds.

RATIO

: Sets the ratio of the compression between 2:1, 4:1, and 10:1 (depending on calibration).

RELEASE

: Sets the release time of the compressor, measured in seconds.

: Adds gain to make up for that lost when compressing. Counterclockwise is unity gain.

MAKE-UP

COMPRESSOR

: Engages compression. In the

compressor, including the

FILTER

: Engages the sidechain filters or external sidechain input. In position 1 (counterclockwise) the filters are

and have no effect on the signal. Positions 2-4 are high-pass filters, with the corner frequencies indicated

OFF

in hertz. Position 5 is a shelf filter that deemphasizes low frequencies and emphasizes high. Position 6 is for the

external sidechain input.

DRY/WET

: Blends the dry signal with the compressed signal when

: Engages the

MIX

DRY/WET

disabled and has no effect.

: Sums the left and right signals at the start of the sidechain detection circuit. The default,

MONO SC

position is how the original console worked.

XFMR

: Switches between a clean, IC-based output and a saturated transformer output. The default,

position is closest to the original.

DRIVE

: Switches between three drive settings. These increase the gain going to the transformer and attenuate

after it to maintain unity gain while increasing saturation.

OUT

stage if it is engaged.

XFMR

control for parallel compression. In the

position the signal still runs through the audio path of the

MIX

is engaged.

position the mix circuitry is completely

OUT