dji ROBOMASTER Gebruikershandleiding - Pagina 5

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} dji ROBOMASTER. dji ROBOMASTER 6 pagina's. Dart trigger device
Ook voor dji ROBOMASTER: Gebruikershandleiding (5 pagina's), Gebruikershandleiding (15 pagina's)

Pagina afdrukken

Usage

Status Descriptions

Configuration Status

The trigger device enters configuration status within 3 seconds after powering on. In this status, users can

configure the light color or switch modes.

Work Status

The trigger device automatically enters the work status after being powered on for 3 seconds or when

configuration is completed. In this status, the trigger device will light up in the preset color for 5 seconds if it

detects acceleration or impact. If the trigger device detects acceleration or impact again within the 5 seconds,

the timer for the light will reset.

Malfunction Status

If the hardware is damaged, the trigger device will blink red and blue alternately to indicate that the trigger

device needs to be replaced. Make sure to replace any damaged hardware before competition.

Mode Descriptions

The trigger device includes Practice mode and Competition mode. Practice mode is set by default when using

for the first time.

Mode Switch

When set to Practice mode and in the configuration status, the trigger device will enter Competition mode if

it receives a signal of entering Competition mode from the designated transmitter. In Competition mode, the

trigger device will not respond to a standard NEC protocol signal.

When set to Competition mode and in the configuration status, the trigger device will exit from Competition

mode and enter Practice mode if it receives an exit signal from the designated transmitter.

Practice Mode

In Practice mode, the trigger device will glow solid in the last preset color after powering on. If there is no

operation within 3 seconds, the trigger device light will turn off and enter work status. If a standard NEC

protocol signal is received within 3 seconds, the trigger device will blink a different color three times before

entering work status.

Competition Mode

In Competition mode, the trigger device will blink in the last preset color at a frequency of 3 Hz. If there is no

operation within 3 seconds, the trigger device light will turn off and enter work status. If a configuration signal

from the designated transmitter is received within 3 seconds, the trigger device will blink in the corresponding

color three times before entering work status.

RoboMaster Dart Trigger Device User Manual