dji ROBOMASTER Gebruikershandleiding - Pagina 4

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} dji ROBOMASTER. dji ROBOMASTER 6 pagina's. Dart trigger device
Ook voor dji ROBOMASTER: Gebruikershandleiding (5 pagina's), Gebruikershandleiding (15 pagina's)

Pagina afdrukken

RoboMaster Dart Trigger Device User Manual

Installation Instructions

1. Use at least four M2.5 screws (two for each mounting plate) to secure the trigger device to the tip of the

dart. It is recommended to use washers with the screws.

2. Connect the power port of the trigger device to a power supply with a voltage of 5 V.

Installation Requirements

After installation, make sure that each side of the trigger device as shown in the figure below is not blocked by

the dart.

1. Left Side

2. Top

3. Right Side

4. Bottom

A camera or other device can be installed to the hollow structure of the trigger device. The area of the device

you wish to install should not exceed the shaded area shown in the figure below.

Φ17.30

1. Shaded Area

Trigger Device Non-Obstruction Area

Trigger Device Hollow Structure

B-B