dji ROBOMASTER Посібник користувача - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник користувача для Зарядний пристрій dji ROBOMASTER. dji ROBOMASTER 6 сторінок. Dart trigger device
Також для dji ROBOMASTER: Посібник користувача (5 сторінок), Посібник користувача (15 сторінок)
Друкувати сторінку
RoboMaster Dart Trigger Device User Manual
Installation Instructions
1. Use at least four M2.5 screws (two for each mounting plate) to secure the trigger device to the tip of the
dart. It is recommended to use washers with the screws.
2. Connect the power port of the trigger device to a power supply with a voltage of 5 V.
Installation Requirements
After installation, make sure that each side of the trigger device as shown in the figure below is not blocked by
the dart.
1
1. Left Side
2. Top
1
3. Right Side
4. Bottom
A camera or other device can be installed to the hollow structure of the trigger device. The area of the device
you wish to install should not exceed the shaded area shown in the figure below.
Φ17.30
Φ17.30
1. Shaded Area
©
4
2020 DJI All Rights Reserved.
2
Trigger Device Non-Obstruction Area
2
B
B
1
B
1
B
Trigger Device Hollow Structure
3
3
B-B
B-B
4
4