dji ROBOMASTER 사용자 설명서 - 페이지 4
{카테고리_이름} dji ROBOMASTER에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. dji ROBOMASTER 6 페이지. Dart trigger device
dji ROBOMASTER에 대해서도 마찬가지입니다: 사용자 설명서 (5 페이지), 사용자 설명서 (15 페이지)
페이지 인쇄
RoboMaster Dart Trigger Device User Manual
Installation Instructions
1. Use at least four M2.5 screws (two for each mounting plate) to secure the trigger device to the tip of the
dart. It is recommended to use washers with the screws.
2. Connect the power port of the trigger device to a power supply with a voltage of 5 V.
Installation Requirements
After installation, make sure that each side of the trigger device as shown in the figure below is not blocked by
the dart.
1
1. Left Side
2. Top
1
3. Right Side
4. Bottom
A camera or other device can be installed to the hollow structure of the trigger device. The area of the device
you wish to install should not exceed the shaded area shown in the figure below.
Φ17.30
Φ17.30
1. Shaded Area
©
4
2020 DJI All Rights Reserved.
2
Trigger Device Non-Obstruction Area
2
B
B
1
B
1
B
Trigger Device Hollow Structure
3
3
B-B
B-B
4
4