Artila Matrix 604 Snelle installatiehandleiding - Pagina 2

Blader online of download pdf Snelle installatiehandleiding voor {categorie_naam} Artila Matrix 604. Artila Matrix 604 4 pagina's.

Serial Port
The four serial ports can be configured as RS-232, RS-422 or RS-
485 by software. They use RJ45 connector and the pin
assignment are shown as following table.
Port 1: RS-232/422/485
RS-232: RXD,TXD,RTS,CTS,DSR,DTR,DCD,GND
RS-422: TXD+, TXD-,RXD+,RXD-,GND
RS-485: DATA+,DATA-,GND
Port 2/3/4:
RS-232: RXD,TXD,RTS,CTS,GND
RS-485: DATA+, DATA-, GND
Serial Console & GPIO Port:
Serial console port is used for locally accessing Matrix 604
system using RS-232 port. The console port uses RJ45 connector
and is next to Ethernet port. Therefore please be careful to plug
in the right connector
Port 0: RS-232:RXD,TXD,GND
Therefore you need to prepare or purchase the serial console
cable (CB-RJ2CON-100) in order to use the serial console port .
In addition to the serial console signal, the console RJ45 port also
provides GPIO ( programmable I/O signal) function. The GPIO
port is CMOS I/O and can be programmed as digital input or
output. Power up setting is digital input mode with 75K ohm pull
up resistor.
Power Connector
Connect the 9 to 48VDC power line to Matrix 604. If the
power is properly supply, the power LED will show a solid
green color.
Ethernet Port
The Ethernet Port use RJ45 connector
Console
Factory Default Settings
LAN 1 IP Address: DHCP
Login: None
Password: None
Serial Console Port:
-
+
Power on and System boot up
Once Matrix-604 is correctly power on, you can see the
message prompt from the serial console port. The system
starts from the initial table and a batch file,autoexec.bat
which is located at \NandFlash will follow up. Therefore user
can edit the autoexec.bat file or init table for your auto run
program. To skip the autoexec.bat, please repeatedly key $
(shift+4) right after system boot up.
Initial Table:
WinCE uses initial table to decide the order of program/service
to start after power on. You can use init command to configure
the initial table as follow:
Number 70 is Artila Manager and Number 71 is WinCE remote
display control.
Baud rate: 115200
Data format: 8 Bits, No Parity, 1 Stop bit (N,8,1)
Flow Control: None
Terminal type: VT100