Artila Matrix 604 Manual de instalação rápida - Página 2

Procurar online ou descarregar pdf Manual de instalação rápida para Ambiente de trabalho Artila Matrix 604. Artila Matrix 604 4 páginas.

Imprimir página

Serial Port

The four serial ports can be configured as RS-232, RS-422 or RS-

485 by software. They use RJ45 connector and the pin

assignment are shown as following table.

Port 1: RS-232/422/485

RS-232: RXD,TXD,RTS,CTS,DSR,DTR,DCD,GND

RS-422: TXD+, TXD-,RXD+,RXD-,GND

RS-485: DATA+,DATA-,GND

Port 2/3/4:

RS-232: RXD,TXD,RTS,CTS,GND

RS-485: DATA+, DATA-, GND

Serial Console & GPIO Port:

Serial console port is used for locally accessing Matrix 604

system using RS-232 port. The console port uses RJ45 connector

and is next to Ethernet port. Therefore please be careful to plug

in the right connector

Port 0: RS-232:RXD,TXD,GND

Therefore you need to prepare or purchase the serial console

cable (CB-RJ2CON-100) in order to use the serial console port .

In addition to the serial console signal, the console RJ45 port also

provides GPIO ( programmable I/O signal) function. The GPIO

port is CMOS I/O and can be programmed as digital input or

output. Power up setting is digital input mode with 75K ohm pull

up resistor.

Power Connector

Connect the 9 to 48VDC power line to Matrix 604. If the

power is properly supply, the power LED will show a solid

green color.

Ethernet Port

The Ethernet Port use RJ45 connector

Console

Factory Default Settings

LAN 1 IP Address: DHCP

Password: None

Serial Console Port:

Power on and System boot up

Once Matrix-604 is correctly power on, you can see the

message prompt from the serial console port. The system

starts from the initial table and a batch file,autoexec.bat

which is located at \NandFlash will follow up. Therefore user

can edit the autoexec.bat file or init table for your auto run

program. To skip the autoexec.bat, please repeatedly key $

(shift+4) right after system boot up.

Initial Table:

WinCE uses initial table to decide the order of program/service

to start after power on. You can use init command to configure

the initial table as follow:

Number 70 is Artila Manager and Number 71 is WinCE remote

display control.

Baud rate: 115200

Data format: 8 Bits, No Parity, 1 Stop bit (N,8,1)

Flow Control: None

Terminal type: VT100