Custom Crimp CC150MOB Series Gebruikershandleiding - Pagina 9
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Custom Crimp CC150MOB Series. Custom Crimp CC150MOB Series 15 pagina's. Hose crimper with dial micrometer and 240 tons of crimping force has the capability to crimp up to 2" industrial hose
Pagina afdrukken
CC150MOB
To begin, use your hose and fittings manufacturer's crimp specifications to
select the correct hose, fitting, die and final crimp diameter for your project
Note:
Prior to crimping the hose it is important to verify the insertion length.
This number should be provided by your hose and fitting manufacture, or in
your hose and fittings manufacturer's specifications manual.
Set the dial micrometer to the setting recommended by your hose and fitting
manufacturer for the combination of hose and fitting being crimped,
then lock the micrometer.
Micrometer Setting Example:
Each 100 on the Micrometer represents 1 mm above the closed diameter of
the die set. For example, with a 50mm die installed and the Micrometer set at
250, the finished crimp diameter would be 52.5 mm.
(50mm + 2.5mm) = 52.5 mm
Insert the hose assembly from either direction into the crimper, taking care not
to disturb the die set. Hold the assembly in place until the crimp is complete.
Note:
Consult your hose and fitting manufacturer's specifications for the
correct insertion depth for the hose and fitting being crimped.
• Activate the crimp cycle by pressing and holding the green close
button or the foot switch, until the crimper shuts off indicating the
crimp is complete.
• After the dies retracted remove the hose assembly.
Check the crimp diameter of the finished assembly with calipers or
micrometers, to be certain that it is within the specifications as outlined
in your hose and fittings manufacturer's crimp specifications.
Making Small Adjustments:
• If necessary, the crimp size can be adjusted by making small adjustments on
the unit's micrometer.
Measure the finished crimp diameter, add or subtract the difference to reach
your target diameter, then set that number on the dial micrometer and make a
crimp. Check the final crimp diameter with calipers to confirm that it is within
your hose and fitting manufacturer's specifications.
Notes:
• If the crimp is under-crimped, turn the dial counter-clockwise.
• If the crimp is over-crimped, turn the dial clock-wise.
General Production Hose Crimper
CRIMPING PROCEDURE
9