djpower FLAME MACHINE HF-210 Gebruikershandleiding - Pagina 8

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} djpower FLAME MACHINE HF-210. djpower FLAME MACHINE HF-210 16 pagina's.

Error and Warning
Page
5.3.3.
Menu Map Setup
Press MENU to enter the setting interface. Press MENU to enter different options until you return to the main interface.
5.4.
Operation
5.4.1.
Orientation
Please read the safety distance print on the top panel of the FLAMER carefully.
Tip switch
ON
WindowLight
ON
Angle Selection
Full Angle
language
English
E1: Pressure Err
P:0 V:12
E2: Tip Err
P:0 V:12
E3: Bat Err
P:0 V:12
E4: System Lock
P:0 V:12
E5: Relief Err
P:0 V:12
Setting the tilt protection
(In case it is ON, if the machine tilts over 45° , it
stops the unit from firing)
Setting LED light which illuminates the fluid level
indicator
Angle selection
Language setting
Pressure
failed
to
reach
pressurizing, system will report E1.
Possible fault: No fuel; pump failure; pipeline
problem etc.
The machine tilts over 45° , it stops running,
system will report E6
Machine stops running due to battery voltage
higher than15V or lower than 10V for 5s
contentiously.
Possible fault: the battery is low.
Safety lock located at TEST MODE
Pressure relief error due to pipeline can't release
pressure.
Possible fault: pressure release valve failure;
pipeline problem or control system problem etc.
- 7 -
ON/OFF
ON/OFF
Full
105 , Left 90 , Left
75 , Left 60 , Left
45 , Left 30 , Left
15 ,middle 0,right
15 , right 30 , right
45 , right 60 , right
75 , right 90 , right
105
100%
after
13s
Angle , Left