Custom Crimp CC4-50 Gebruikershandleiding - Pagina 10

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Custom Crimp CC4-50. Custom Crimp CC4-50 17 pagina's.

LUBRICATION & MAINTENANCE

Page

Proper lubrication is essential to prevent damage to the

machine and to assure accurate crimping.

Lubricate the crimping head after each 100 crimping cycles.

A lubricant containing 60% molybdenum di-sulphide must be

used. A can of lubricant (P/N DMA-12) is furnished with the

machine. The can must be shaken for a minute in order to

assure that the thick lubricant at the bottom of the can is

thoroughly mixed with the propellant.

Close the Master Dies until the face of the die is approximately

17mm (.65 in) above the flange as shown.

Spray the lubricant into the front and rear of the dies as well as

into the diffuser hole in the center of the die.

Every 400 crimp cycles, remove the soft protective pads from

between the Master Dies and spray lubricant into the spring

cavity area.

Be certain to replace the protective pads as dirt and chips can

cause permanent damage to the crimping head