Artistry In Motion Big Shots Bedienings- en onderhoudshandleiding - Pagina 10
Blader online of download pdf Bedienings- en onderhoudshandleiding voor {categorie_naam} Artistry In Motion Big Shots. Artistry In Motion Big Shots 12 pagina's. Wireless transmitter and receiver
Ook voor Artistry In Motion Big Shots: Instructies voor laden en vuren (2 pagina's)
Pagina afdrukken3.1.2 ARM: Connect the Wireless Big Shots® Receiver connector to the Big
3.13
3.14
3.1.5 STORE: When finished turn off the receiver "ON/OFF" switch to the
Artistry In Motion, Inc.
Tel: 818.994.7388
Ver 08/20
receiver so that their separation does not exceed ¾ of this maximum
range. Verify that the input voltage is adequate by observing the flashing
green "BATTERY" and "ARMED" lights on the receiver and transmitter,
respectively. Operation of these indicators is as described in section 1.3
above. Turn the transmitter lock switch back to "Safe" position, and turn
off the receiver.
Shots® solenoid valve plug as described in section 1.4 above. With the
"ARM" switch turned off, turn on the receiver power switch. The red
indicator should remain off. Check that the green "BATTERY" indicator is
only flashing in bursts of one, two or three to indicate input voltage
If this indicator exhibits continuous or erratic behavior, there is a
signal being received, which will cause firing when the "ARM"
switch is turned on.
attempting to use the system.
CHECK: Verify that the Big Shots® accumulator tank has not been
pressurized and that the barrels have not been filled with confetti or
streamers. Verify that the "Battery" indicator does not show reception of
firing signals. Now, move the "ARM/SAFE" toggle from "SAFE" to "ARM".
FIRE: Turn the transmitter toggle switch to its "Armed" position, and
press the "FIRE CH A" button to actuate the receiver output. The "FIRE"
and the "BATTERY" lights on the receiver should both light up red. You
should hear the solenoid valve in the Big Shots® Cannon click as it
opens and closes. If the "Fire" and "Battery" lights flash red, but you do
not hear the solenoid click, you should verify that the solenoid plug is
completely seated in the receiver receptacle, and that the solenoid is fully
seated on the valve stem. Repeat this test until you are certain of the
continuity of your system. When you are satisfied with the continuity of
your system, return the transmitter and the receiver to the "SAFE"
positions. You are now ready to fill the Big Shots® accumulator tank and
load the confetti or streamers in the barrels.
Please note: The "Fire" buttons must be depressed for at least 100
milliseconds to produce a transmitter output. The transmitter should be
held with the antenna in the same orientation as the Receiver Antenna,
away from the body and other conductive objects to achieve maximum
range and communication reliability. Generally, the higher the transmitter
is held, the greater the range.
"OFF" position and "ARM/SAFE" switch to the "SAFE" position. You also
should turn the transmitter lock switch back to its "SAFE" position. These
actions will stop further drain of the power sources. If the receiver is to be
stored for a prolonged period, charge its batteries as described in section
1.5 above.
19411 Londelius Street, Northridge, CA 91324
Fax: 818.994.7688
Determine the source of the interference before
Website:www.artistryinmotion.com
status.
Page 10