Artistry In Motion Big Shots Bedienings- en onderhoudshandleiding - Pagina 9
Blader online of download pdf Bedienings- en onderhoudshandleiding voor {categorie_naam} Artistry In Motion Big Shots. Artistry In Motion Big Shots 12 pagina's. Wireless transmitter and receiver
Ook voor Artistry In Motion Big Shots: Instructies voor laden en vuren (2 pagina's)
Pagina afdrukken2.4
THE FIRE BUTTONS
These buttons are snap action dome switches under a sealed overlay, labeled
"Fire CH A" and "Fire CH B", respectively. They have a high spring constant
which requires a firm depression for actuation, decreasing the likelihood of
accidental depression.
The transmitter is idle while no buttons are pressed. Continuous transmission
occurs while "Fire CH A" or "Fire CH B" is pressed
Output firing pulses are stretched to a minimum duration of 1 second to ensure
that all cues fire reliably, even when the "Fire CH A" button is pressed for a
shorter period of time. Note that it is not necessary to wait for the completion of
the 1-second firing pulse period before firing subsequent cues. They can be fired
as fast as the operator can press the button, provided that each button
depression lasts at least 0.1 second.
2.5
THE TRANSMIT INDICATOR.
This is a high intensity red indicator, visible in direct sunlight, which lights
continuously while the transmitter is generating RF output. It is located between
the two buttons. It will light even if the battery voltage is below the low battery
detect threshold.
2.6
THE BATTERY.
Power is supplied from an alkaline 9-volt battery, accessible beneath a slide-out
door on the backside of the transmitter. This battery should be replaced when
required by conditions described in section 2.3 above. In order to prevent the
possibility of damage due to battery leakage, the battery should always be
removed if the transmitter is to be stored for a prolonged period. Damage due to
battery leakage is not covered under the warranty.
3.0
OPERATION AND MAINTENANCE.
This
section describes the recommended operating procedure and maintenance for the
transmitter-receiver system.
3.1
OPERATION.
3.1.1 PRE TEST: Before connecting the Big Shots® solenoid valve to the
Artistry In Motion, Inc.
Tel: 818.994.7388
Ver 08/20
receiver perform a reception test by observing the receiver battery light
while pressing the transmitter button. Be sure that the receiver is in the
"Safe" mode, and select Channel A on the channel select switch. Turn
the key on the Wireless Big Shots® Transmitter to "Armed" and press the
"Fire CH A" button. The receiver battery light will illuminate a solid green
when the transmit button is depressed. An assistant may be needed for
this test. If the receiver location will be fixed, determine the limits of the
range in the current environment, and position the transmitter and
19411 Londelius Street, Northridge, CA 91324
Fax: 818.994.7688
Website:www.artistryinmotion.com
Page 9