Alula RE210T Installatiehandleiding - Pagina 2

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Alula RE210T. Alula RE210T 4 pagina's. Indoor motion sensor-pet immune 2gig compatible

Pagina afdrukken

Install

using the included 3M VHB

sensor on a wall or in a corner. The tape should be applied

to the back when wall mounting or to the back bevels when

corner mounting. Alternatively, screw mounting can be done

by punching out the screw mounting holes.

Installation Tips

• Mount 7.5 to 9.5 feet from the floor for an optimal

balance between catch performance and pet

immunity.

• Remove the cover and circuit board before trying

to punch out the screw mounting holes.

• Ensure the bug foam stays intact and snug around

the IR sensing element when re-installing the

circuit board.

External Contact (not evaluated by ETL)

• Use a normally-closed contact because the motion sensor will transmit an

alarm when it sees the external contact open.

• Do not use end-of-line resistors.

Pro Tips

Walk test mode is entered by pressing the motion

sensor's tamper button. The walk test lasts three

minutes.

Walk Test Operation

• The walk test LED turns on when motion

is sensed.

• The motion sensor performs a

re-calibration after each activation. The

re-calibration takes about 30 seconds.

The sensor will NOT sense motion

during the re-calibration.

• Wireless transmissions are sent for each

detection, so walk test mode can also

be used to test the panel.

3M VHB tape works great if the surface is properly

prepared and firm pressure is applied for over 10

seconds.

Surface Preparation

• Clean the surface

• Ensure the mounting surface

temperature is above 50 °F

Motion lockout is active for three minutes after a motion event is detected. During the

motion lockout period, motion events will be ignored.

Motion sensitivity can be adjusted by the sensitivity jumper on the circuit board.

• Jumper Installed (lower sensitivity): Detects person in 3 to 5 steps.

Increases pet immunity. Usually for security applications.

• Jumper NOT Installed (higher sensitivity): Detects person in 2 to 4 steps.

Usually for occupancy applications.

tape to adhere the motion

Mounting Screw Holes

Walk Test LED

Cover Tamper Switch

Bug Foam IR Sensing Element

Low - Jumper ON

High - Jumper OFF

Battery

External Contact

Sensitivity