Alula Connect+ Snelstarthandleiding - Pagina 3
Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Alula Connect+. Alula Connect+ 8 pagina's.
Ook voor Alula Connect+: Handleiding voor hardware-instellingen (2 pagina's)
Pagina afdrukken
Figure E - Typical Burglary Protection Installation
7
Install the sensors
around the premise. Figure E shows common
uses. All intrusion sensors are already setup to
communicate with your system. PRO TIP: Choose a
central location for the Connect+ Hub to maximize
sensor range.
Install the door window sensors
8
the protective backing from the 3M VHB
pressing the sensor halves in place lightly. Ensure
the space between the sensor and the magnet
is less than 3/4". When satisfied with the door
window sensor placement, press and hold each
section in position for 20 seconds. See Figure F.
Figure F - Door Window Sensor Placement
WRONG
Page 3
Connect+
in the desired locations
by removing
®
tape,
OK
BEST
9
Install the motion sensors
the desired wall locations using the
included 3M VHB tape. If installed
in a corner, apply VHB to the 45°
bevels on the back of the housing.
For a flat wall mount, apply VHB
to the back of the housing. VHB is
permanent on painted wallboard,
clean and dry the area before application. Place
motion sensor between 7.5' and 9.5' from the floor.
This is the correct height range to avoid false alarms
created by pet movement. Press and hold sensor
in place for 20 seconds. Refer to the installation
guide provided with your sensor to complete your
installation. Note the sensor is already enrolled to
your Connect+ Hub.
on
Bottom