3M 710 Gebruiksaanwijzing - Pagina 11

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} 3M 710. 3M 710 20 pagina's. Splicing rig
Ook voor 3M 710: Brochure & specificaties (4 pagina's), Specificaties (4 pagina's)

Pagina afdrukken

5.3 Wrap the group to be spliced with the conductor

group holder. Dress the pairs over the colored peaks

with the conductor ends exiting towards the color

code guide. Do not pull the conductors tight to the

back of the connector. Use the error tester tool to

check for correct conductor placement.

5.4 Push the "T" bar forward and down until contact

is made with the conductors. Pull the handle down

to the stop, seating and cutting the conductors in

the bridge module. Remove the excess conductors.

Engage the handle into the retaining clip, pull the

"T" bar up, and place into the open position.

5.5 Place a cap on the module body. Use finger pressure

to push down the cap to pre-engage it to the module

body. The cap latches should face the color code

guide.

5.6 Pull the "T" bar up above the cap. Push the "T" bar

forward and down until contact is made with the cap.

Pull the handle down to the stop, seating the cap into

the bridge module body. Engage the handle into the

retaining clip, pull the "T" bar up, and place into the

open position. The 25-pair bridge splice module is

complete.

78-815-304--E