DLS DD33-40 Gebruikershandleiding - Pagina 8

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} DLS DD33-40. DLS DD33-40 20 pagina's. 600w /3 channel audiophile cool running digital amplifier

Pagina afdrukken

REM (Remote Trigger)

This terminal must be connected to a switched +12V- source.Typically, remote turn -on leads are provided at the source

unit that will turn on and off the amplifier in correspondence with the source. If the source unit does not have a remote turn-on

lead, then a switched +12V supply must be used, like the ACC, +12V

Run a minimum of 18 gauge wire from the amplifier location to the source of the switched +12V lead. If possible, route this

wire on the same side of the vehicle as your power cable. Connect the source remote output to the wire. Go back to the amplifier

and cut the wire to length. Loosen the screw terminal marked REM on the amplifier using an Allen wrench. Insert the stripped

(bare) portion of the wire into the terminal and tighten the screw securely

Amplifier features specially tooled sorderless terminals for power (Batt +),

ground , remote and speaker connection. For maximum transfer of

voltage and signal the bare wire needs to be inserted as far as possible

into the terminal before tightening the set screw.

Hand tighten the set screw and make sure the connection is secure to

prevent possible arcing due to loose screws.

NOTE:

set screws in the terminal blocks by hand and NOT a power drill. This will

prevent stripping or other possible damage to the amplifier.

It is highly recommended that an Hex wrench is used to tighten the