DLS CLASSICAMPENG03 Installeren en bedienen - Pagina 3
Blader online of download pdf Installeren en bedienen voor {categorie_naam} DLS CLASSICAMPENG03. DLS CLASSICAMPENG03 16 pagina's.
Pagina afdrukken
Tools and material needed
Tools:
# # # # #
Flat and Phillips screwdrivers
# # # # #
Wire cutter
# # # # #
Wire stripper
# # # # #
Electric drill with drills
# # # # #
Crimping tool
# # # # #
Digital multimeter or test lamp
# # # # #
Wire brush, scraper or a piece
of an abrasive sheet to remove
paint for a good ground connection
#
Grease to protect the ground
connection from oxidation
Material:
#
Speaker wire: minimum
12 AWG = 4 mm
2
13 – 16 AWG = 1,5-2,5 mm
speakers
#
Sheet metal screws for mounting the
amplifier to the amplifier board and the
amplifier board to the car + some extra
for fuse holder, amplifier ground etc.
# # # # #
Electrical insulation tape
#
½ inch thick plywood or particle board for
the amplifier to be mounted upon.
Amplifier installation kit:
If available,buy an amplifier installation kit. It
contains normally all you need. This is what you
have to buy if you buy the items separately
#
20- 25 feet = 6- 7.5 meter power cable,
preferably AWG 8 = 10 mm
#
1 pc of fuseholder to install close to the
car battery + fuse 50 Ampere.
#
20 feet of AWG 15 = 1,5 mm
remote turn on / off cable from radio.
#
RCA-cable for input from radio.
- 20 feet or 5 meter for trunk installations
-12 feet or 2 – 3 meter for under seat
installations
#
Two min. 8 gauge ring crimp terminals –one
for connection to the battery plus and one
for the amplifier ground connection.
#
Two heavy fork crimp terminals to connect
+ and – to amplifer – but you do only need
them if you use heavy cable or to make the
installation look nicer.
#
Four to eight fork crimp terminals to
connect the speaker cables – but you do
only need them if you use heavy cables or
want the installation to look nicer.
#
One fork crimp terminal to connect the
remote wire to the amplifier, but you need
only to make it look nicer.
#
Four to eight splicers to connect speaker
cables to high level input cable, if high level
input is used.
#
Wire ties
#
Insulating grommet or insulating tube
for subwoofers
2
for other
2
or heavier
2
wire for
Routing wires
Stereo
head unit
Professional Tip:
If amplifier installation kits are available with diffe-
rent size of power cable, chose the most heavy
power cable to improve sound quality and to allow
more amplifiers to be installed now or later.
If possible buy AWG 4 = PL 21 mm
performance.
CA20, 21, 40 & 50
2
cable for best
3