eta eHACK Gebruiksaanwijzing - Pagina 6

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} eta eHACK. eta eHACK 20 pagina's. Flue gas recirculation
Ook voor eta eHACK: Gebruiksaanwijzing (8 pagina's)

Pagina afdrukken

Inserting the sliding rake

When the sliding rake is inserted into the boiler, the

alignment of the cam on the bottom must be observed.

This must always be closest to the side of the boiler on

which the conveying system is mounted.

Fig. 2-9: Note the alignment of the cam

The sliding rake is already assembled. If the room

height is not sufficient to insert the entire sliding

rake, the rake can be dismantled in the middle. After

insertion, the sliding rake has to be screwed together

again.

Fig. 2-10: Sliding rake dismantled

Mounting the lever

Mount the lever for operating the cam on the sliding

rake. Install the lever so that it can actuate the cam.

Fig. 2-11: Cam

Fig. 2-12: Lever

Connect the sliding rake with the de-ashing

Attach the connecting rods of the sliding rake to the de-

ashing levers. For this purpose, use the two special

screws (see illustration).

Fig. 2-13: Securing the connecting rod

www.eta.co.at

Installation