Acquaer AUP033-5 Handmatig - Pagina 5

Blader online of download pdf Handmatig voor {categorie_naam} Acquaer AUP033-5. Acquaer AUP033-5 13 pagina's. Automatic submersible utility pump

Pagina afdrukken

Note: Make certain you unwind the garden hose completely. Kinks in the hose will restrict the pump,

preventing it from priming, which is the first step to pumping water. The water level must be at

approximately 1-1/2 in. for the pump to prime and operate.

1. Plug the pump (A) into a 115 volt GFCI power outlet.

WARNING: Do not let plug fall in water and do not stand

in water while the pump (A) is plugged in.

Automatic Operation

The pump (A) will only turn on if there is approximately 1-1/2 in. of water around the pump. Water must

make contact with the sensor probes of the pump in order for it to turn on.

When the pump (A) removes water down to approximately 1/4 in., the pump will run for an additional 30

seconds and then turn off.

Note: If the pump (A) does not turn off, remove the pump and check to make sure that water or other

debris is not still contacting the sensor probes.

The pump can remain plugged in and will automatically turn back on when water reaches approximately

1-1/2 in. again.

Note: Do not disassemble the motor housing. This motor has NO repairable internal parts and

disassembling may cause an oil leak or dangerous electrical wiring issues.

Problem

1. Probes covered in debris

2. Blown fuse/tripped breaker

Pump does

3. Plug disconnected

not start or

4. Thermal overload

run

5. Corroded plug

6. Motor failed

1. Screen blocked

2. Hose kinked or coiled

3. Hose diameter too small

Pump cannot

4. Hose length too long

pump water

5. Impeller loose on shaft

out

6. Impeller broken

OPERATION INSTRUCTIONS

TROUBLESHOOTING

Possible Cause

On at 1-1/2 in.

On at 1/4 in.

1. Clean sensor probes

2. Replace fuse/reset breaker

3. Secure plug

4. Unplug the pump for 30 minutes, then

plug in

5. Clean plug prongs

6. Call 1-888-538-0082

1.Clean screen

2. Straighten hose

3. Use larger diameter hose

4. Use shorter hose

5. Reassemble impeller

6. Call 1-888-538-0082

Corrective Action