ASI RM2000 Operatie - Pagina 3
Blader online of download pdf Operatie voor {categorie_naam} ASI RM2000. ASI RM2000 19 pagina's.
Pagina afdrukken
2022/03/16 04:45
4 line version
2 line version
The status line at the bottom of the display indicates the command set (H high or L low), the XY
encoder mode (R rotary or L linear), and the Z encoder mode (R rotary or L linear). The next two
numbers show the next position to move to for ring buffer, and the number of positions stored,
respectively, separated by a colon (:). Controllers with the Auto-Focus option display the focus value
on this line as well. On the right side is a time clock. Some error codes are displayed in place of the
clock for a few seconds after they occur.
Mode 3 - SW 1 & 2 UP Dual Display with Status Line Shown
4 line version
2 line version
In this mode, two sets of number are shown for each axis. The number on the left is the current
position reported by the axis encoders. The number on the right is the target position that the
controller is trying to achieve.
Mode 4 - SW 1 UP & 2 DOWN Dual Display with Firmware Version Line Shown
There are several status indicators that may appear on the right side of the axis line display (in
display columns 19 or 20). The meaning of these indicators is listed in the table below.
Table 1: Status Indicators in Order of Priority per Column
Applied Scientific Instrumentation - https://asiimaging.com/docs/
3/18
MS2000, MFC2000 and RM2000 OPERATION