BlueSky Designs Mount'n Mover DP-T5 Handleiding voor bevestiging

Blader online of download pdf Handleiding voor bevestiging voor {categorie_naam} BlueSky Designs Mount'n Mover DP-T5. BlueSky Designs Mount'n Mover DP-T5 4 pagina's. Tobii i-13

Pagina afdrukken
DP-T5
Attaching the Tobii I-13 or I-16 to a Mount'n Mover with a Tilt Plate
Tobii I-13
DP-T5
1
QCR
x4 (8-32 x 2")
The DP-T5 consists of the Quick Connect Receiver
(QCR), the DP-1x2, and four 8-32 x 2" screws.
*
Tobii I-16
Reconfigure screws for an I-16
1
Attach the DP-1x2 to the QCR
Two Counter sunk holes
DP-1x2
Close up of
counter sunk
holes at the top
Attach the DP-1x2 to the QCR with TWO of the
2" screws
(use the two counter sunk holes)
The other two
2
Assemble QRP to DP-T5
screws are holding
the parts together.
Take apart before
step #2
DP-1x2
Use the four screws that come with the DP-T5 to go
through the Quick Release Plate (QRP), through the
DP-1x2 and into the Quick Connect Receiver (QCR)
2
Attach QRP to DP-T5
QCR
QRP
Remove the
QRP from the
Mount'n Mover
Tilt Plate
Quick Release Plate is attached using the other TWO 2"
screws. Go through the QRP, the DP-1x2, and into the
lower two holes on the QCR.
QRP
DP-1x2
QCR
Counter sunk holes
DP-T5
two screws (8-32 x 2") through
top two holes on the QRP
3
Attach QCR to Tobii Device
Tobii Device Plate
Slide Up
Slide the DP-T5 onto the connecting grooves on
the Tobii device plate until it "clicks" in place.
3
Attach QCR to Tobii Device
Slide
Up
Slide the DP-T5 onto the connecting grooves on
the Tobii device plate until it "clicks" in place.
Tobii
Device
Plate
page 1 of 4