Ambifuego KALIDO77 Instructies voor gebruik, installatie en onderhoud - Pagina 12

Blader online of download pdf Instructies voor gebruik, installatie en onderhoud voor {categorie_naam} Ambifuego KALIDO77. Ambifuego KALIDO77 16 pagina's.

Pagina afdrukken
USER INFORMATION
Press and hold the SET button until the P1 is displayed, and the
time flashes. Set the hour by pressing the (▲) and set the minutes by
pressing the (▼) .
Briefly press SET button for the next burner cycle time.
Once all 4 times are set, press OFF to complete programming.
Manual Override
The system has a "Manual Override" feature that allows manual
operation without battery power. For manual operation, turn the
override knob to the "MAN" position. There is an opening that allows
access to the magnet stem, this should be pushed in to allow gas to
pass to the pilot. This stem must be held in whilst the Piezo igniter *
is depressed to spark the Pilot. The stem must be held in for a further
15 seconds until the pilot light establishes. If the Pilot does not hold
when the stem is released, repeat the process.
When the pilot is established, the "Override" Knob may be turned to
the "ON" position. Control of the gas is then possible using the
second control.
To turn the appliance off using the manual override, flip the "ON-
OFF" switch.
Please note * - The Manual Piezo Igniter is only available if
purchased as an optional Extra, however the manual "ON-OFF" and
Manual flame height setting is always available.
12
INSTALLER INFORMATION
Simple Version Up and Lower control only
This requires no external electrical power to operate. The receiver
unit has a unit that has only one lead. This lead has two plugs (of
Receiver
different sizes), these will plug into the two spade plugs on the front
the two items. Provided that the distance between the receiver and
handset is less than 10m, the system will work.
The receiver unit can be hidden away under or behind the fire,
ensure that the receiver is located in an area that has a temperature
below 60ºC, and that the customer knows where the receiver is for
future battery replacement.
Check the system.
Battery Cover
Lead
of the Gas Control
unit.
Install the batteries
into the receiver and
the handset; these
will be 4 x 1,5V AA
alkaline and 9V PP3
alkaline respectively.
This
Receiver/Handset
works using sound
waves, and as such
no direct line of sight
is required between
21