ACR Electronics RLB-41 Handleiding productondersteuning - Pagina 12

Blader online of download pdf Handleiding productondersteuning voor {categorie_naam} ACR Electronics RLB-41. ACR Electronics RLB-41 20 pagina's.

Category II bracket mounting: The mounting location must be easily accessible for manual deployment and

performance of required maintenance and functionality tests. Typical locations include near the helm station or just inside

the companionway door.

To use the bracket's three pre-drilled screw holes, first remove the beacon from the bracket by pressing the release and

pulling the beacon bottom forward (see illustration below). The beacon will slide down and out of the bracket. Hold the

bracket in place to mark the screw holes or use the provided mounting template. The use of #8 pan head stainless steel

fasteners and #10 3/8" (0.95 cm) washers is recommended. Be sure to confirm that fasteners will not contact any wires

or plumbing before drilling pilot holes.

NOTE: FASTENERS AND WASHERS NOT INCLUDED.

To remove the beacon

from the bracket, press

back on release tab

Step 3: Install The Beacon

To install the beacon in the Category I or Category II bracket, insert the top cap first at a slight angle and then press the

bottom casing until the beacon clicks and is firmly supported. The beacon can only be mounted inside the bracket with

the ON/Test buttons facing out (see Category I bracket illustration on page 11 and Category II bracket illustration above).

Pull the bottom of the

beacon out and down to

release

12 |

P a g e