Floe V2602 LENGTH BUNKS Instrukcja montażu - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja montażu dla Systemy podnoszenia Floe V2602 LENGTH BUNKS. Floe V2602 LENGTH BUNKS 8 stron.
Drukuj stronę
INSERT UPRIGHT TUBES INTO CLAMP WELDMENTS AND ATTACH USING (2) ½" NUTS, HAND TIGHT
ONLY (FIGURE 1.3). ADJUST HEIGHT AND TORQUE TO 70 FT-LBS (FIGURE 1.4).
FIGURE 1.3
2X
FIGURE 1.4
2X
NOTE:
BUNK/CRADLE PAD DISCLAIMER
DUE TO THE LARGE VARIETY OF BOAT HULL DESIGNS, WE STRONGLY RECOMMEND
UPRIGHTS MAY HAVE TO BE CUT TO
ALLOW FULL TRAVEL OF CRADLE ONCE
THAT YOU CONSULT WITH YOUR BOAT'S MANUFACTURER TO INSURE THAT YOUR ARE
SUPPORTING YOUR BOAT PROPERLY TO AVOID ANY POTENTIAL DAMAGE.
FINAL PLACEMENT IS ESTABLISHED.
SHEET 4 OF 8