Coastal WEATHERPAK TRx2 Podręcznik użytkownika - Strona 8
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Stacja pogodowa Coastal WEATHERPAK TRx2. Coastal WEATHERPAK TRx2 18 stron.
Drukuj stronęCHAPTER 5
5-1
RECEIVER/DISPLAY CONNECTIONS
®
The WEATHERPAK
and features a 4 x 20-character vacuum florescent data display housed in a ruggedized enclosure.
1. Connect the radio antenna to the appropriate connectors on the back of the display box.
2. Connect the data cable to the Serial connector. Please Note
have a Serial port, use a Serial to USB converter method.
3. Plug the display box power cord into a power
source (110 VAC, unless otherwise marked).
4. Toggle the power switch to the 'up' position
(located on the front, lower right corner of the
display box).
illuminate,
the
immediately, and the display will wait to receive
the transmission from the weather station.
5-2
CONNECTING TO A COMPUTER WITH A
SERIAL PORT
1. Plug one end of the Serial data cable into the
Serial connector on the back of the display box and the other end into an available 9-pin
Serial port on your PC.
2. Turn the receiver on.
3. The receiver power indicator light should now be illuminated. The system will take a few
seconds to boot-up.
4. With the WEATHERPAK
the boot-up routine, the red data light will blink approximately every 30 seconds as an
indication that data is being received from the WEATHERPAK
5-3
CONNECTING TO A COMPUTER WITH A USB PORT
In the event your computer does not have a Serial port available, or you simply prefer to use a USB
port, you must employ the "Serial to USB" converter. Connect the Serial cable to the converter.
Follow the directions provided with the Serial to USB device.
P/N: 0302-117-002 Rev. C
SYSTEM ASSEMBLY
TRx2 Receiver/Display box, as the name implies, contains the radio receiver
The power indicator light will
screen
will
assembled and running, and after the display box has completed
illuminate
Figure 3 – Receiver/ Display Box
®
WEATHERPAK
User's Manual
: If your computer does not
®
.
TRx 2
8