Aero-Spa AP 1000 Instrukcja instalacji - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Wanna z hydromasażem Aero-Spa AP 1000. Aero-Spa AP 1000 13 stron.
Również dla Aero-Spa AP 1000: Instrukcja instalacji (12 strony)

Drukuj stronę

Equipment Set-up

For best results it is highly recommended that the hot tub be drained

and thoroughly cleaned to remove residual dirt and contaminants

prior to installation of the Aero-Spa system.

Set the equipment on a level solid spacer block that is at least 2 – 3/8"

thick and at least 10' from the hot tub that is not prone to flooding

(equipment is weather proof but not waterproof) (Figure 2). If the

supplied ozone tube is not of adequate length, move the equipment

closer to the hot tub but not closer than 10'. Do not extend or shorten

the ozone tube. If the tube is too long, coil the excess tube in an 8"

diameter coil.

Do not splice or modify the air line setup, an improperly sized ozone tube will

detrimentally affect the performance and life of this product and may void the

1.) Connect the 20' ozone tube (connected to diffuser) to the fitting

exiting the underside of the Generator. Secure using provided

cable tie

2.) Loop the ozone tube over the edge of the hot tub (Figure 3).

3.) Align the ozone tube with the center seam of the cover and allow it

to lie in the gap to ensure that it is not pinched when the cover is

closed. The clear protector tube must be positioned in the gap

(See Figure 3).

warranty!

Figure 2: Unit Placement