American Standard Reliant 250CA104.020 Instrukcja instalacji Pielęgnacja i konserwacja - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja instalacji Pielęgnacja i konserwacja dla Toalety American Standard Reliant 250CA104.020. American Standard Reliant 250CA104.020 12 stron. Two-piece toilet
Drukuj stronę
5
BOLT CAP
WASHER
NUT
INSTALL TOILET
a.
Position toilet squarely to wall and, with a rocking motion,
press bowl down fully on wax ring and flange.
Alternately tighten nuts until toilet is firmly seated on floor.
DO NOT OVERTIGHTEN NUTS
OR BASE MAY BE DAMAGED!
b. Install caps on washers. (If necessary, cut bolt height to
size before installing caps.)
c. Smooth off the bead of sealant around base.
Remove excess sealant.
7
INSTALL TOILET SEAT
Install toilet seat in accordance with manufacturer's directions.
8
A
Connect water
supply line.
(Sold separately)
Hand tighten nut.
B
Turn on water supply.
CLOSET FLANGE
CLOSET BOLT
!
CAUTION:
6
INSTALL TANK
a.
Install large rubber gasket over threaded outlet
on bottom of tank and lower tank onto bowl so
that tapered end of gasket fits evenly into bowl
water inlet opening.
b.
Insert tank mounting bolts and rubber washers
from inside tank, through mounting holes, and
secure with metal washers and nuts.
c.
With tank parallel to wall, alternately tighten
nuts until tank is snugged down evenly against
bowl surface.
DO NOT OVERTIGHTEN NUTS MORE
THAN REQUIRED FOR A SNUG FIT!
WARNING: Overtightening of
!
water supply line nuts could
result in breakage and potential
flooding. If the connection leaks
after hand tightening, replace
the supply line. Do not use any
type of sealant on the water
supply
plumber's putty, pipe dope, or
any other type of sealant will
void the warranty.
- 2 -
RUBBER
WASHER
RUBBER
TANK MTG.
GASKET
BOLTS
WASHER
NUT
!
CAUTION:
connection.
Use
of
7302485-100 10/20