Canon Color imageCLASS MF8180c Instrukcja obsługi dla sieci - Strona 14
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla sieci dla Wszystko w jednej drukarce Canon Color imageCLASS MF8180c. Canon Color imageCLASS MF8180c 49 stron. Color laser copier - printer - scanner - fax - network capabilities
Również dla Canon Color imageCLASS MF8180c: Instrukcja zdalnego interfejsu użytkownika (40 strony), Skrócona instrukcja obsługi (25 strony), Instrukcja obsługi rozrusznika (35 strony)
Drukuj stronę
Preparation for Protocol Settings
Before you specify the machine's protocol settings, it is necessary to specify the
machine's IP address to enable communication between the machine and your
computers. You can use any of the following to specify the settings. Specify the
settings using the easiest method.
•
The machine's operation panel
•
The ARP/PING commands
•
NetSpot Device Installer (Canon utility software included in the User Software CD)
IMPORTANT
•
In the following operations, the machine's MAC address is necessary. To check the MAC
address from the machine's operation panel, print a USER DATA LIST. (Refer to Chapter
6, "Reports and Lists," in the Facsimile Guide.)
•
Before you perform the following operations in this section, check that the machine is ON
and connected to the network.
•
If you are using ARP/PING commands, the following steps directly allocate the IP
address to the machine. For this machine, in addition to direct allocation of the IP
address to the machine, you can use DHCP, BOOTP, or RARP to specify the IP address.
When the machine is started or reset, it checks whether DHCP, BOOTP, or RARP is
being used, and then allocates an IP address using the first available setting method.
Because the machine's IP address is automatically allocated at this time, it is not
necessary for you to perform the following operations in this section. However if you are
reallocating the IP address, or if DHCP, BOOTP, or RARP is not used, perform the
following operations.
Preparation for Protocol Settings
2
2-3