AmeriGlide RUBEX Instrukcja instalacji - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Systemy podnoszenia AmeriGlide RUBEX. AmeriGlide RUBEX 16 stron.
Również dla AmeriGlide RUBEX: Instrukcja obsługi (8 strony)
Drukuj stronę11819 P/N: 16169 Rev D
INSTALLING PLASTIC CHAIN AND TRAVELING POWER CABLE
Step 1: Lay cable and chain in track. It will
extend a little more than half way down the
track.
Step 2: Take one side of the traveling cable
and truck into the bottom channel in the middle
of the track.
NOTE: The power cable will face in toward
the metal channel.
Step 3: Feed the other side of the cable into
the channel on the opposite side.
Note: Check every chain link. If unsnapped,
the chain will not bend correctly.
Step 4: After laying the trailing cable and guide chain into the track
channel, pull down on the cable to make sure there is no slack and it is
straight under the left channel tight against the side.
Step : While holding the cable tight in place, use a
/
" driver to run
1
4
the self drilling screw into the track utilizing one of the two holes in the
guide chain mounting bracket. Two holes are provided in the mounting
bracket in the event that one of the holes would happen to be directly
over a splice between two pieces of track.
Rubex Stair Lift Install Manual | www.Ameriglide.com | 866-378-6648
11 //
16