Amerisolar Wolfram-BAT-10.24 Instrukcja instalacji - Strona 18

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Akcesoria do kamer Amerisolar Wolfram-BAT-10.24. Amerisolar Wolfram-BAT-10.24 20 stron.

Worldwide Energy and Manufacturing USA Co., Limited

Note:

•Must be operated by professionals;

•When connecting the communication harness, avoid incorrect connection of the

communication port;

•When connecting in parallel, it is strictly forbidden to touch the total positive and negative

poles of the battery pack at the same time to avoid high voltage damage;

•During installation, the circuit breaker should be placed in the off state.

Step 5: Close the cabinet door

After completing the above steps, close the cabinet door.

Step 6: Connect the battery system and the inverter

Connect the power cables and communication cables from the cabinet to the inverter as

shown in the figure below.

Figure 14. connection between battery system and PCS

5. Operating

Precaution: Before starting up, please make sure that the cabinet has been correctly

installed and connected Boot steps:

•Open the cabinet door;

•Press the black button on the two battery boxes to the closed state, and then press and hold

the red soft start button of either battery box for 3 seconds. All the panel indicators flash once

and then the green operation indicator flashes at 2 second intervals, indicating that the

system is booting normally;

•After confirming that the positive and negative poles of the cabinet output have been

correctly connected to the inverter or after insulation treatment, close the two circuit breakers

on the cabinet；

•Close the cabinet door and start the machine.

Note: Before disconnecting the cabinet to the inverter, make sure that the battery system

is turned off.

Shutdown steps：