AMERITRON SDC-102 Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Kontroler AMERITRON SDC-102. AMERITRON SDC-102 13 stron. Screwdriver antenna controller

SDC-102 Screwdriver Controller with Memory

Installation (A)

Controllers that have six wire leads.

There are six wires that need to be connected in order for the controller to

function properly.

The red wire needs to be fused and connected to the vehicle's +12

VDC supply. The size of the fuse depends upon the current requirement

of the antenna motor. Typically a 5 Amp slow-blow fuse will work.

Some installations may require additional wire. Use 16 AWG wire to

add additional length.

The black wire needs to be connected to the vehicle (station) ground.

If the supplied red and black wires are not long enough, Use 16 AWG

wire to add additional length.

WARNING: Do not reverse the polarity of the Red and Black

wires. Damage will occur to the controller.

The remaining four wires are connected to the antenna. The Green and

Yellow wires are connected to the motor. The polarity of the motor

connection determines the direction of the antenna. If the motor moves

in the wrong direction, swap the wires or see the menu setup section for

setting the correct direction.

The Brown and White wires are the sensor wires and should be

connected to the magnetic sensor on the antenna. There is no polarity

associated with these wires. The following table shows the wire color

and connections.

Red

Black

Green

Yellow

Brown

White

You will need to connect wires to each of these four wires, so that they will

reach your screwdriver antenna. Use quality insulated wire for these extensions.

The motor control wires should be no smaller than 18 AWG. the sensor wires

should be no smaller than 24 AWG.

manufacturer's suggestions about routing these wires for a mobile installation.

Avoid routing control wires with the feed line. Make sure a RF choke is placed

around the control lines at the antenna.

Installation (B)

Controllers that have the 4 pin Molex plug.

Instruction Manual

+12VDC

Vehicle Ground

Antenna Motor

Magnetic Sensor

Take care and follow your antenna