DoorHan PCB-SW Instrukcja programowania - Strona 15
Przeglądaj online lub pobierz pdf Instrukcja programowania dla System otwierania drzwi DoorHan PCB-SW. DoorHan PCB-SW 20 stron. Control board
Również dla DoorHan PCB-SW: Instrukcja programowania (20 strony)
Drukuj stronę
9. Leaf 2 will start to close.
10. Press the «+» button and leaf 2 will start to slow down.
11. Press the «+» button once more and leaf 2 will stop.
12. Leaf 1 will start to close.
13. Press the «+» button and leaf 1 will start to slow down.
14. Press the «+» button once more and leaf 1 will stop.
15. Two short beeps will sound, and the program will automatically exit the programming mode.
NOTE:
If safety devices are engaged then the display will show flashing «Er» (Error). Remove the cause of the error and repeat
learning.
NOTE:
To set the leaves movement without deceleration, press the «+» button twice when the desired operating time is
reached.
2.3. DISPLAY INDICATION
The display consists of two seven-segment indicators. They indicate the status of the control board switching contacts and of
the gate.
Indicator
0
1
Segment
0
1
2
3
4
5
6
7
0
1
2
3
4
5
6
7
OPERATOR PROGRAMMING
Description
Lights when the «FOTO OP» contact is closed
Not used
Not used
Lights when the «FOTO CL» contact is closed
Lights when the «PED» contact is closed
Lights when the «SBS» contact is closed
Lights when the «STOP» contact is closed
Not used
Indication of the processor operation
(segments are switched clockwise)
15