DoorHan PCB-SW 프로그래밍 지침 매뉴얼 - 페이지 15
{카테고리_이름} DoorHan PCB-SW에 대한 프로그래밍 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DoorHan PCB-SW 20 페이지. Control board
DoorHan PCB-SW에 대해서도 마찬가지입니다: 프로그래밍 지침 매뉴얼 (20 페이지)
9. Leaf 2 will start to close.
10. Press the «+» button and leaf 2 will start to slow down.
11. Press the «+» button once more and leaf 2 will stop.
12. Leaf 1 will start to close.
13. Press the «+» button and leaf 1 will start to slow down.
14. Press the «+» button once more and leaf 1 will stop.
15. Two short beeps will sound, and the program will automatically exit the programming mode.
NOTE:
If safety devices are engaged then the display will show flashing «Er» (Error). Remove the cause of the error and repeat
learning.
NOTE:
To set the leaves movement without deceleration, press the «+» button twice when the desired operating time is
reached.
2.3. DISPLAY INDICATION
The display consists of two seven-segment indicators. They indicate the status of the control board switching contacts and of
the gate.
Indicator
0
1
Segment
0
1
2
3
4
5
6
7
0
1
2
3
4
5
6
7
OPERATOR PROGRAMMING
Description
Lights when the «FOTO OP» contact is closed
Not used
Not used
Lights when the «FOTO CL» contact is closed
Lights when the «PED» contact is closed
Lights when the «SBS» contact is closed
Lights when the «STOP» contact is closed
Not used
Indication of the processor operation
(segments are switched clockwise)
15