DoorHan PCB-SW 프로그래밍 지침 매뉴얼 - 페이지 16

{카테고리_이름} DoorHan PCB-SW에 대한 프로그래밍 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DoorHan PCB-SW 20 페이지. Control board
DoorHan PCB-SW에 대해서도 마찬가지입니다: 프로그래밍 지침 매뉴얼 (20 페이지)

페이지 인쇄

2.4. ADVANCED PROGRAMMING

To perform advanced programming do the following:

1. Press and hold the «P» button for 10 seconds to enter the advanced programming. The left part of the display will show

«0», and the right part will show the menu item (see the Advanced Programming table).

2. Pressing the «+» or «-» buttons select the required menu item.

3. Press «P» to enter the menu item, the value of the adjusted parameter will start flashing on the display.

4. Pressing the «+» or «-» buttons change the value of the selected item.

5. Press «P» to save new value and exit to the main menu.

6. Having adjusted all the required parameters press «R» to exit the programming menu.

NOTE:

If you need to exit to the main menu without saving the parameters press «R».

Menu item Function

Pass door or single-leaf gate automation mode:

0.0

Y — enabled; n — disabled

Force on the 1st leaf:

0.1

1 — minimum force; 6 — maximum force

Force on the 2nd leaf:

0.2

1 — minimum force; 6 — maximum force

Maximum force at the start:

0.3

Y — enabled; n — disabled

Pre-activation of signal lamp(5 sec):

0.4

Y — enabled; n — disabled

Operation logics of the electric lock terminals (19-21):

0.5

Y — элетромагнитный; n — электромеханический

Closing safety devices activation:

0.6

Y — reverse movement after the gate opening is freed of obstruction; n — immediate reverse movement

Automatic gate closing after activation of photocells:

0.7

Y — enabled; n — disabled

Gate opening/closing with buttons held pressed (faulty remote control):

0.8

Y — enabled; n — disabled

Prohibition of the control commands acceptance during gate opening:

0.9

Y — enabled; n — disabled

Separate control logics:

S-B-S button — gate opening and stopping;

1.0

PED button — gate closing and stopping;

Y — enabled; n — disabled

1st leaf opening time with PED button:

1.1

0 — disabled; 1 — 3 sec; 2 — 4 sec; 3 — 5 sec; 4 — 8 sec; 5 — 15 sec; 6 — 20 sec; 7 — 25 sec; 8 — 30 sec; 9 — 40 sec

Remote programming:

1.2

Y — enabled; n — disabled

9.8

Reset to factory settings

9.9

Software version

2.5. RESET TO FACTORY SETTINGS

To reset the control board parameters to factory settings enter the advanced programming menu and select «9.8» item, press

the «P» button. The display will show «rE», press and hold the «P» button for five seconds. «rE» will stop flashing and the board

will be reloaded; short audio signal will be given. After this operation, all settings will be default.

NOTE:

When resetting to factory settings, the receiver memory is not cleared.

OPERATOR PROGRAMMING

Default