Astralpool SLX Instrukcja instalacji i obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Oświetlenie podwodne Astralpool SLX. Astralpool SLX 6 stron. Underwater niche lights for fibreglass pools
Również dla Astralpool SLX: Szczegółowe instrukcje (6 strony), Skrócona instrukcja obsługi (4 strony), Instrukcja instalacji (7 strony), Instrukcje instalacji (4 strony)

7. When the concrete has dried, remove the foam cover from the niche. Fill the recess around the niche

with a waterproof sealant (2 part epoxy). Keep the sealant flush with the niche front edge and

concrete wall surface.

8. To install the light mounting ring into the niche:

a. Apply PVC cement to the swivel surface of the mounting ring (item 75811) and also to the inside

of the niche where the mounting ring is likely to rest (approx. 20mm inside niche).

b. For easier installation and maintenance of the light, it is highly recommended that the mounting

ring be installed according to the following description. The mounting ring has a large "X" mark

that should be installed into the niche such that the marker is at the 12 o'clock position. Please

see the following image, which highlights the marker and its correct position. Press the mounting

ring into the niche, with the marker at 12 o'clock, until the ring sits flush against the pool concrete

wall. Check for correct installation before the glue sets.

X marker at 12

o'clock position

Mounting Ring

9. Press the second, smaller polystyrene foam cover (item 26939) into the mounting ring. This will

prevent dirt and debris entering the niche during rendering or tiling and will also help maintain

roundness under the weight of the tiles.

10. Now apply the render or tiles, ensuring that the finished tile/render surface is level with the front edge

of the mounting ring.

Tiled interior pool surface must

be finish flush with raised edge

of mounting ring

Tiles & Glue or Render

ATTENTION: Interior pool surface must finish flush with the raised edge of the mounting ring, or it

will not be possible to properly install the light.

ATTENTION: Do not install the light until the pool has been washed with acid.

Inst.375 Astral Pool CONCRETEInstructions V10.15

Note the "X" mark, which should be

located at the 12 o'clock position when

the ring is installed into the niche.

Waterproof sealant

applied to this recess

Apply PVC solvent

cement

This screw hole should be

located at the 6 o'clock position.

Mounting Ring

Waterproof Sealant

Concrete