Astria Fireplaces Rhapsody54 Series Instrukcja instalacji - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Akcesoria do kominków Astria Fireplaces Rhapsody54 Series. Astria Fireplaces Rhapsody54 Series 12 stron. Linear direct-vent fireplaces accessory kits
Figure 14 - Routing wiring
ear ledge has backlight wire routing
2. If the fi rebox r
holes, proceed with the instructions in Route and
connect optional fi rebox panel backlight kit wiring
and install lamp assemblies below.
If the rear ledge does not have backlight wire
f i r e - p a r t s . c o m
mounting holes, follow the instructions detailed in
Route and connect optional fi rebox panel backlight
kit wiring and install lamp assemblies as shown on
this page.
Route and connect optional fi rebox panel backlight kit
wiring and install lamp assemblies
1. Remove the three (3) cover plates in the lower front face
of the back panel. Discard the cover plates, but retain the
screws.
Figure 15 - Removing the cover plates, and routing the wiring
2. Route one set of three leads (white/green/black) through each
backlight wire routing hole in the rear ledge (Figure 14).
3. Route one set of three leads (white/green/black) through each
hole in the lower front face of the back panel (Figure 15).
6
INNOVATIVE HEARTH PRODUCTS • LINEAR GAS FIREPLACES • REQUIRED AND OPTIONAL ACCESSORIES
Backlight Wire
Routing Holes
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
of three leads, connect the green wire to a
4. With one set
lamp (Figure 16).
Figure 16 - Attaching green wire to fi rebox panel backlight
kit lamp, and inserting lamp into bracket
(with green wire attached) into a bracket
5. Insert the lamp
until the spring clip is engaged (Figure 16).
e white (neutral) wire and black (hot) wire
6. Connect th
(Figure 17).
Figure 17 - Attaching black and white wires to fi rebox
panel backlight kit lamp
the process in step 4 through step 6 for the
7. Repeat
two remaining lamp assemblies.
three (3) lamp assemblies in the exact
8. Insert the
orientation shown (Figure 18).
Figure 18 - Installing the lamp assemblies
he lamp assemblies using the six (6) previously
9. Secure t
removed screws from the cover plates (Figure 18).