Astria Fireplaces Rhapsody54 Series Panduan Petunjuk Instalasi - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Aksesori Perapian Astria Fireplaces Rhapsody54 Series. Astria Fireplaces Rhapsody54 Series 12 halaman. Linear direct-vent fireplaces accessory kits

Halaman Cetak

Figure 14 - Routing wiring

ear ledge has backlight wire routing

2. If the ﬁ rebox r

holes, proceed with the instructions in Route and

connect optional ﬁ rebox panel backlight kit wiring

and install lamp assemblies below.

If the rear ledge does not have backlight wire

f i r e - p a r t s . c o m

mounting holes, follow the instructions detailed in

Route and connect optional ﬁ rebox panel backlight

kit wiring and install lamp assemblies as shown on

this page.

Route and connect optional ﬁ rebox panel backlight kit

wiring and install lamp assemblies

1. Remove the three (3) cover plates in the lower front face

of the back panel. Discard the cover plates, but retain the

screws.

Figure 15 - Removing the cover plates, and routing the wiring

2. Route one set of three leads (white/green/black) through each

backlight wire routing hole in the rear ledge (Figure 14).

3. Route one set of three leads (white/green/black) through each

hole in the lower front face of the back panel (Figure 15).

INNOVATIVE HEARTH PRODUCTS • LINEAR GAS FIREPLACES • REQUIRED AND OPTIONAL ACCESSORIES

Backlight Wire

Routing Holes

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

of three leads, connect the green wire to a

4. With one set

lamp (Figure 16).

Figure 16 - Attaching green wire to ﬁ rebox panel backlight

kit lamp, and inserting lamp into bracket

(with green wire attached) into a bracket

5. Insert the lamp

until the spring clip is engaged (Figure 16).

e white (neutral) wire and black (hot) wire

6. Connect th

(Figure 17).

Figure 17 - Attaching black and white wires to ﬁ rebox

panel backlight kit lamp

the process in step 4 through step 6 for the

7. Repeat

two remaining lamp assemblies.

three (3) lamp assemblies in the exact

8. Insert the

orientation shown (Figure 18).

Figure 18 - Installing the lamp assemblies

he lamp assemblies using the six (6) previously

9. Secure t

removed screws from the cover plates (Figure 18).