Astro Machine AstroJet M1C Skrócona instrukcja obsługi - Strona 4
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Urządzenie do tworzenia etykiet Astro Machine AstroJet M1C. Astro Machine AstroJet M1C 6 stron.
Również dla Astro Machine AstroJet M1C: Skrócona instrukcja obsługi (2 strony)
Drukuj stronę5. Insert new Ink Tanks (label up) into appropriate
color slots [B]. Close three Ink Tank Latches.
INSTALLATION TIP: Make sure Ink Tanks
seat properly. Insert Tank into appropriate
Ink Station, then pull Ink Tank back about an
inch and push forward firmly to insure that
Ink Nozzles penetrate seals on Tanks.
6. Click "Continue" on
Confirm screen, then
"Refresh Ink Levels" on
User Interface screen. Ink
colors fill in as Ink Tanks
are installed. If ink colors do not fill in after a few
seconds, click "Replace Ink Tanks" again and
reinstall Ink Tank(s).
7. Close Front Cover.
WARNING!
INK IN INK TANKS MAY BE HARMFUL IF
SWALLOWED. KEEP NEW AND USED INK
TANKS OUT OF REACH OF CHILDREN.
DISCARD EMPTY INK TANKS IMMEDIATELY.
Step 6
Install Printhead Cartridge
Handle Printhead Cartridge with extreme care to avoid
damage that could degrade print quality.
Use ESD protection when handling.
Hold Printhead Cartridge by handles
ONLY.
DO NOT touch ink couplings, nozzle
surface or electrical contacts.
DO NOT unpack Printhead Cartridge
until Printer is ready for installation.
Once unwrapped, delay in installing
Printhead can compromise print quality.
DO NOT place an unwrapped Printhead
on any surface before installing. Protect
Printhead from dust, fibers, dirt and
other contaminants at all times.
1. With Printer power ON, open Top Cover.
Printhead Latch [1] should be already opened.
NOTE: If Latch is closed, open using Printhead
Release buttons in Printer Toolbox.
Remove Cap Protectors on Ink Nozzles [2].
Open Latch fully to retract Ink Nozzles.
DO NOT PRY OR MANUALLY LIFT PRINTHEAD
COVER OR COVER MAY BREAK. ONLY OPEN
THE COVER USING THE PRINTHEAD RELEASE
COMMANDS IN THE PRINTER TOOLBOX.
Page 4
CAUTION
CAUTION