Canon CN10x25 IAS S/E1 Instrukcja obsługi - Strona 20
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Obiektyw kamery Canon CN10x25 IAS S/E1. Canon CN10x25 IAS S/E1 34 stron. Zoom lens
Drukuj stronę
- 1. Fcc Regulations
- 2. General Safety Information
- 3. Handling the Product
- 4. Maintenance and Inspection
- 5. How to Mount
- 6. Available Accessories
- 7. Dimensions of Parts
- 8. Iris Gain Adjustment
- 9. Mode Setting
- 10. Zoom Operation
- 11. Focus Operation
- 12. Iris Operation
- 13. Extender Operation
- 14. Macro Operation
- 15. Switch Operations
- 16. Product Specifications
5 OPERATION
5-1-5. Shuttle-Shot Function
This function allows you to switch between the current zoom position and the preset zoom position at the
maximum speed.
Present position
Before using shuttle-shot function, the shuttle function must be assigned to the VTR, RET, or AUX
switch, or the AUX1 or AUX2 switch on the zoom demand. This manual describes the Shtl function
assigned to the VTR switch. For details, refer to "5-6 Switch Operations".
Setting the shuttle memory position
Zoom Rocker Seesaw
MEMO Switch
5-1-6. Speed Preset
This function allows you to call the preset zoom speed any time you zoom. Assign the Sped function to the
VTR, RET, or AUX switch, or AUX1 or AUX2 switch on the zoom demand. In this manual, operations are
described on the assumption that Sped function was assigned to the VTR switch.
1. Setting the zoom speed and direction
Zoom Rocker Seesaw
MEMO
Switch
Fr1P Switch
The Shtl
switch is
held down.
Max
speed
Suttle memory position
Shtl Switch
Shtl Switch
Sped Switch
The Shtl
switch is
released.
Max
speed
Zoom to the position that you want to store. Keeping this
position, press the Shtl switch while holding down the
MEMO switch.
NOTE
1.
The position you stored here is different from the
one you set in "Framing Preset" mentioned later.
The stored position set here is retained even after
the power is turned off.
2.
The operation with the Shtl switch is given the
priority over that with the zoom rocker seesaw. The
operation with the zoom rocker seesaw is disabled
while the Shtl switch is pressed.
Operate the zoom rocker seesaw to determine the zoom
speed and direction (toward telephoto angle or widest angle)
which you want to store, and press the MEMO switch.
NOTE
The stored zoom speed is applied to the framing preset.
E14
Original position