Asus AAEON PICO-APL1-SEMI Instrukcja szybkiej instalacji - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja szybkiej instalacji dla Płyta główna Asus AAEON PICO-APL1-SEMI. Asus AAEON PICO-APL1-SEMI 4 stron.

Step 7: Insert the PICO-APL1 board into the

chassis assembly with the processor side toward

the heatsink. DO NOT place the CMOS battery

between the board and heatsink.

Step 9: Thread the power button cable through the hole for the power button. Plug the cable into the front panel

connector (CN3 in user manual). NOTE: The white dot indicates PIN 1 connector, make sure the connector is

properly aligned. Next, gently push the power button in until it is secure (you will hear a 'snap'). Be careful not to

tangle the power button cable with the CMOS battery cable.

Step 10: Peel the backing off of the tape on the CMOS battery. Gently press the battery onto the

PICO-APL1 board to secure it.

Step 11: Attach the bottom chassis by first lining up the right side, then swivel the chassis into place.

NOTE: the bottom chassis does not slide directly on, it must swivel into place as shown in the figure.

Step 12: Ensure the bottom chassis is properly lined up and attached. Use black screws to secure, two

screws on the bottom and one screw on the left and right sides of the chassis.

Step 8: Check that the I/O ports are properly

aligned. Secure board with four nickel screws.