Dorf INCA Instrukcje instalacji - Strona 2

Przeglądaj online lub pobierz pdf Instrukcje instalacji dla Produkt hydrauliczny Dorf INCA. Dorf INCA 2 stron. Pull down sink mixer

INCA - PULL DOWN SINK MIXER

PLUMBERS ADJUSTMENT INSTRUCTIONS

Adjusting the HOT LIMIT RING (ANTI-SCALD STOP RING)

The cartridge fitted in this mixer has been factory pre-set to deliver

the maximum available hot water temperature. To use the ANTI-SCALD

feature adjust the cartridge as follows:-

Carefully remove plug (4). Using 2.5mm allen key (3) loosen screw (2)

and remove handle (1). Unscrew cap (5) taking care not to damage the

decorative finish. (See details on side 1 of this sheet.)

To remove the Hot Limit Ring (7) from the cartridge (9), use a small thin

flat bladed screwdriver and carefully lever in an upwards direction.

Rotate the Ring (7) in a clockwise direction then refit the Ring (7) onto

the cartridge (9).

Note:- Start by rotating the Ring (7) in small increments, then check the

hot water temperature with the mixer handle in the fully open maximum

hot water position. The Ring (7) can be removed & repositioned until the

desired maximum hot water temperature is achieved.

Ensure the Ring (7) is pushed fully down onto the cartridge (9), then replace

cap (5), tightening by hand. Fit handle (1), taking care that it is pushed

fully onto cartridge stem, tighten screw (2) and replace plug (4).

Adjusting the WATER VOLUME LIMIT SCREW

The cartridge fitted in this mixer has been factory pre-set to deliver

the maximum flow of water when the mixer handle is in the fully open

position. However the flow of water may be reduced by adjusting

the cartridge as follows:-

Carefully remove plug (4). Using 2.5mm allen key (3) loosen screw (2)

and remove handle (1). Unscrew cap (5) taking care not to damage the

decorative finish. (See details on side 1 of this sheet.)

Using a small thin flat bladed screwdriver, adjust screw (8) in an anti-clockwise

direction.

Note:- Start by rotating the Screw (8) in small amounts then check the

flow of water with the mixer handle in the fully open position. Readjust

the screw until the desired water flow is achieved.

Replace cap (5), tightening by hand. Fit handle (1), taking care that it is

pushed fully onto cartridge stem, tighten screw (2) and replace plug (4).

WATER EFFICIENT TAPWARE

Fig. 2

Fig. 3

(SIDE 2 OF 2)

IS1387A(03/15)