Canon LV-7215 Specyfikacja - Strona 22

Przeglądaj online lub pobierz pdf Specyfikacja dla Projektor Canon LV-7215. Canon LV-7215 47 stron. Mounting hanger for low ceilings
Również dla Canon LV-7215: Specyfikacja (22 strony), Broszura i specyfikacje (2 strony), (Japoński) Instrukcja montażu i instalacji (8 strony)

Drukuj stronę
Canon LV-7215 Specyfikacja
EXPAND SERIAL COMMAD FUNCTIONAL SPECIFICATION for LV-5210/7215/7210
8.6.2

CF_AVDLINECOMMAND

COMMAND
"CF_AVDLINE_%1" [CR]
"UP"............Current Setting+1
%1
"DN"............Current Setting-1
Set AV service MODE vertical resolution value.
(Only valid when it is in the usual Power ON status.)
Details
The setting value is stored in EEPROM. When ALL OFF the projector, the
value will return to the original setting.
When there is no signal, the projector returns "101" [CR].
Acceptable
Response
Unacceptable
8.6.3

CF_AVHPOS COMMAND

COMMAND
"CF_AVHPOS_%1" [CR]
"UP"............Current Setting+1
%1
"DN"............Current Setting-1
Set AV service MODE horizontal position value.
(Only valid when it is in the usual Power ON status.)
Details
The setting value is stored in EEPROM. When ALL OFF the projector, the
value will return to the original setting.
When there is no signal, the projector returns "101" [CR].
Acceptable
Response
Unacceptable
8.6.4

CF_AVVPOS COMMAND

COMMAND
"CF_AVVPOS_%1" [CR]
"UP"............Current Setting+1
%1
"DN"............Current Setting-1
Set AV service MODE vertical position value.
(Only valid when it is in the usual Power ON status.)
Details
The setting value is stored in EEPROM. When ALL OFF the projector, the
value will return to the original setting.
When there is no signal, the projector returns "101" [CR].
Acceptable
Response
Unacceptable
8.6.5

CF_AVSERV COMMAND

COMMAND
"CF_AVSERV_%1" [CR]
%1
"RST"
Set AV horizontal/vertical resolution that is set in such as "CF_A Ｖ
DDOTS"/"CF_AＶＤＬＩＮＥ" to default setting value.
(Only valid when it is in the usual Power ON status.)
Details
The setting value is stored in EEPROM. When ALL OFF the projector, the
value will return to the original setting.
When there is no signal, the projector returns "101" [CR].
"000" [CR]
"101" [CR] ----Input-VIDEO
"000" [CR]
"101" [CR] ----Input S-VIDEO
"000" [CR]
"101" [CR] ----Input-VIDEO
Page
22