Dot Origin VTAP50 Instrukcja instalacji - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Sprzęt sieciowy Dot Origin VTAP50. Dot Origin VTAP50 16 stron. Oem module

3.4 Optional captive cable connection - RS232 and USB

The PCB has a special connector J1 (an 8 pin, 2mm pitch header connector) which can be

used to attach a captive cable with a matching crimp housing, for RS232 or an alternate

USB connection.

The standard connector fitted to the PCB, in most cases, is a Hirose DF11CZ-8DP-2V male

header plug with shroud. The matching crimp housing is the Hirose DF11-8DS-2C.

CAUTION: If the J1 connector on your PCB does not include a shroud, to guide the

matching wires into place, you can use a wider range of mating connectors. Do please take

extra care to ensure your connecting cable is oriented correctly to match the pins.

Figure 3-3 VTAP50 captive power cable or RS232 connection -

CAUTION: There are a small number of VTAP50 v1 Rev 1 units in circulation. Please be

aware that the pins on v1 Rev 1 hardware are pairwise switched.

Figure 3-4 VTAP50 captive power cable or RS232 connection -

VTAP50 OEM MODULE INSTALLATION GUIDE

VTAP50 v1 Rev 2 Hardware onwards

VTAP50 v1 Rev 1 Hardware only

PAGE 6