Douglas Dynamics WESTERN MVP PLUS 44595-1 Instrukcja instalacji - Strona 12
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Akcesoria samochodowe Douglas Dynamics WESTERN MVP PLUS 44595-1. Douglas Dynamics WESTERN MVP PLUS 44595-1 15 stron. Snowplow
Drukuj stronęOPERATIONAL TEST AND FINAL ADJUSTMENTS
FINAL INSPECTION AND ADJUSTMENT
WARNING
Keep 8' clear of the blade when it is being
raised, lowered, or angled. Do not stand
between vehicle and blade or directly in front
of the blade. If the blade hits or drops on you,
you could be seriously injured.
1. Attach snowplow to the vehicle mount. With
snowplow lowered to the ground and on level
pavement, measure the dimension from the
ground to the center of the pivot bar cap screw.
This dimension must be 9‑3/4" to 11‑1/4".
2. With the snowplow attached and on the ground,
place the stand arm in the lower position with
the lock pin engaged and with the stand shoe
fully retracted in the "UP" position. Measure the
distance from the ground to the bottom of the
stand shoe. This distance should be 1‑3/8" to
2‑1/8". The stand can be adjusted to achieve this
dimension by removing the roll pin and selecting
the proper hole in the stand stem. When the stand
height is correct, cut and remove the spring tie.
Lit. No. 43174, Rev. 04
3. Final lift chain link adjustment must be made
after the snowplow is assembled with the proper
pivot plate position. On a level surface, with the
snowplow on the ground and the lift ram fully
collapsed, attach the chains to the lift arm hooks
in the tightest possible link. This adjustment will
provide for optimum transport height, blade float
and stacking stop clearance. When chain tension
is correct, the T‑frame will not contact the lift
frame when the blade is fully raised.
4. Fully raise the blade and verify that it does not
block the headlamp beams. If the blade blocks the
headlamp beams, lower the blade to the ground,
collapse the lift ram and lengthen each chain by
one link. Repeat this process, lengthening the
chains by one link each time, until the blade does
not block the headlamp beams.
5. Raise and lower the snowplow in "Retract" (vee)
position to verify that the hydraulic hoses bow
outward and do not interfere with snowplow
components.
NOTE: Ensure that the base‑end angle ram hoses
are wrapped over the diagonal brace. Adjust
hoses, fittings and wraps as necessary.
Roll Pin
12
9-3/4" to 11-1/4"
1-3/8" to 2-1/8"
July 15, 2020