Comar Systems SLR-350N Instalacja i skrócona instrukcja obsługi - Strona 4
Przeglądaj online lub pobierz pdf Instalacja i skrócona instrukcja obsługi dla Odbiornik Comar Systems SLR-350N. Comar Systems SLR-350N 7 stron. Ais receiver
Drukuj stronęContents of this Box
Before proceeding with the installation of the SLR-350N, please
check the content of the box, which should include:
The SLR-350N AIS receiver.
Universal 100-250VAC/12VDC Power Supply
Antenna connector adaptor
Installation and quick Reference Guide.
2m Network cable.
Installation CD.
Installing the SLR-350N Receiver
Mounting the SLR-350N receiver.
The SLR-350N receiver can be mounted to a suitable bulkhead or
shelf.
Hint:
Select a location away from excessive heat sources, avoid high
levels of vibration and shock
Power.
Fit the universal power supply with the correct adaptor for your local
power. Plug the 2.1mm jack into the rear of the SLR300N and switch
on the power.
Hint:
Alternatively the unit will accept 9-30VDC from an alternative source
capable of supplying 1Amp of current.. The centre pin is Positive.
Installing the antenna
A VHF antenna is not supplied as the type of antenna and cable
requirements differ from each installation. An antenna can be
acquired from a local marine electronics outlet.
Shore based reception is governed by local terrain, however an open
view to the sea with an antenna mounted in the clear at a height of
approximately 20 metres will achieve 25 miles plus, higher gain
antenna can be used on shore to further increase the range.
4
Hint:
The antenna connector type is BNC, 50 ohms.
Hint:
The higher the antenna is located, the greater the range.
Hint:
Mount the antenna with a relatively clear view of the horizon. Large
obstructions that might shade the antenna should be avoided.
Hint:
A higher gain antenna will increase reception range..
Hint:
Normally a omni- directional antenna is recommended however a
directional antenna such as a 3 element yagi can be used to increase range
in one particular direction.
Configuring the SLR-350N Receiver
Connection to a PC by USB.
The SLR350N can be monitored locally by connecting it via the USB
port to a PC. The drivers supplied on the CD create a virtual com
Port so that data can be viewed by the supplied Comar AIS Viewer
program or by any other AIS viewing program which requires a com
port connection.
Connection to a Network.
The SLR350N can be connected to a standard PC, Network Router or
Switch. Note if connecting directly to a PC you will need a crossover
cable.
When connected to a network the yellow LED on the network
connection should be on. If no yellow LED is shown then the unit has
not detected a link. The green LED will blink when data is
transmitted or received.
The CD included with the product contains the program Digi Device
Discovery utility program for setting up and configuring the unit.
5