Comar Systems SLR-350N Instalacja i skrócona instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instalacja i skrócona instrukcja obsługi dla Odbiornik Comar Systems SLR-350N. Comar Systems SLR-350N 7 stron. Ais receiver

Drukuj stronę

Correct operation

Operation of the SLR-350N unit is fully automatic and only requires

power, VHF and data cable connection.

On powering up the unit

●

The green light marked ON should illuminate.

●

The Channel lights should come on brierfly then go off.

●

The channel A and B lights should flash momentarily when

information from nearby transceivers is received.

Data is then output for visual or textual viewing on compatible

electronic charting systems or other systems or devices.

Fault finding

No power light is displayed

●

Check the power supply and that the unit is connected

correctly to a 12 or 24 volt DC supply

●

Check the polarity of the supply is correct. The center pin of

the 2.1mm jack is positive

Channel 1 and Channel 2 lights do not flash

●

Check that a VHF antenna is fitted and correctly connected.

●

Check that the antenna is correctly positioned – i.e. at a

suitable location to visibly 'see' vessels.

DISCOVERY TROUBLESHOOTING TIPS

Firewalls: Check to make sure that any software firewalls (common

examples are Windows Firewall and most popular Anti-Virus

software) are disabled. These can block the discovery process. Also,

any physical firewall will almost certainly block the discovery process

as well.

Trouble discovering a Digi device using Windows XP with

Service Pack 2: You will need to make sure that the Windows

Firewall is disabled. By default it is enabled and will block the port

that the discovery software uses to discover Digi. To disable the

firewall go to Start->Settings->Control Panel->Windows Firewall.

Then click the off button to disable it.

Routers or Switches: Is there a router between the computer

running the discovery utility and the Digi device itself? Normally,

routers will block the discovery process. If possible remove them and

use a hub instead. If there is a switch in between this may or may

not be a problem. Occasionally they are configured to block the

discovery traffic. If unsure use a hub or a direct Ethernet cable

connection. Also, in case the port on your Router/Switch/Hub is bad,

try a different port as well.

Cabling: If nothing else works try using a direct crossover Ethernet

cable directly between the computer and the Digi device. Another

option is to try another Ethernet cable.

Ethernet LED: Check the Ethernet Link LED (Light Emitting Diode)

on the Digi device. Is it lit solid? If not, there is not a valid network

connection and it will not be possible to discover the device.

Network Adapters: Make sure the proper network adapter is

enabled. Also, ensure all other network adapters are disabled. If

more than one network adapter is enabled, this can cause the

discovery process to fail.