AMPHIBICO genesis fs-700 Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria do kamer AMPHIBICO genesis fs-700. AMPHIBICO genesis fs-700 17 stron. For the sony nex fs-700

Drukuj stronę

PREPARING CAMCORDER & HOUSING

INSTALLING THE SADDLE

Place the saddle under camcorder with its handle pointing the back of the

camcorder. Align the three thumb screw's saddle with the camcorder's

tripod mounting holes. Hand tighten the thumb screw to secure the saddle

to the camcorder.

CONNECTING THE SADDLE

REMOTE: Connect the cable from the rear of the saddle to the camcorders

REMOTE jack.

AUDIO: Connect the XLR microphone connector to the camcorder's

INPUT 2 MIC jack, located on the front upper right of the camcorder.

VIDEO: Connect the RCA jack to VIDEO OUT yellow jack input located on

the rear of the camcorder

PREPARING CAMCORDER & HOUSING

PLACING THE CAMCORDER INTO THE HOUSING

By now the camcorder is set, installed to the saddle and ready to be placed

inside the housing.

1. Turn ON the camera.

2. Line up the camcorder and saddle with the docking rails found on the left

and right sides inside the housing. Watch the cables !

3. Insert the camcorder and slide it all the way until the saddle connector

makes contact with the docking tray connector. At this point rotate the saddle locking lever towards the left until it

stops.

CLOSING THE HOUSING

1. While the housing is open, inspect the two o-rings and the sealing surface for dirt and debris. If necessary, clean

them with a lint free tissue. Make sure that the two o-rings and the sealing surface are clean. Then apply a small

amount of lubricant (supplied) to the o-rings.

NOTE: If you have to change your o-rings, make sure you are using the o-rings provided with the package. Using

different o-rings than those in the o-ring kit may cause the housing to leak and result in damage.

2. Make sure that the saddle cables do not block the sealing surface. If any cable gets pinched, the system might

be intermittent or not functioning at all. Close the rear door until the latch begins to engage. then rotate the safety

counter clockwise until it clicks

Page 5