Electrolux Built-In Dishwasher Instrukcja serwisowa - Strona 28

GAS OVENS

IMPORTANT: Disconnect the appliance from the power supply before accessing internal

components.

Access to certain components can be gained by removing the built-in oven partially from its

compartment in the cabinet.

When the oven is partially pulled out, the engineer can access the components in the front

control panel and the electronic control unit. In order to access the other components located

in the rear section, it is necessary to remove the oven completely from the cabinet.

Proceed as follows to remove the oven:

Remove the four screws which secure the oven to the casing. These are located at the

front of the front panel (figg. 47 - 48).

Fig. 47.

IMPORTANT: Before accessing any of the internal components, it is essential to disconnect

the oven from the power supply by removing the plug from the socket or by

positioning the switch on the power circuit (if any) to "OFF".

3.3

Proceed as follows to disconnect the gas supply:

1. Shut off the gas supply valve.

2. Remove the oven from the cabinet.

3. Remove the nut which secures the gas delivery

pipe to the gas coupling on the oven (see fig.

49)

1. GAS INLET COUPLING ON OVEN

2. NUT ON GAS COUPLING

3. GAS SUPPLY HOSE

4. CABINET WORKTOP

SOI 04.04 FV

Fig. 49

28/50

Fig. 48

599 35 96-40