Draper BMSM Instrukcja obsługi - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Elektronarzędzie Draper BMSM. Draper BMSM 20 stron. Bench mounted spindle moulder

ASSEMBLY

- FITTING THE ROUTER BIT GUARD (Fig.8):

- The router bit guard

using the upper and lower blade guides, attach the bit

guard by lining up the fixing holes on the fence and

guard and inserting pin

- FIXING THE REAR FENCE TO THE WORK TABLE

(Figs.9 - 13):

- Place the fully assembled rear moulded fence onto the

work table Fig.9.

- Remove the front panel by removing four cross slot

screws using a screwdriver (not supplied). Fig.10.

Note: Ensure spindle moulder is isolated from the mains

supply.

- Once the front panel has been removed, insert bolt

into the left locating hole from inside the spindle

moulder. Fig.11.

must be used when not

. Fig.8

- 10 -

FIG.8

FIG.9

FIG.10

FIG.11