Draper FlexShade NEXD Instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wyposażenie wnętrz Draper FlexShade NEXD. Draper FlexShade NEXD 12 stron. Clutch-operated small and large hardware
Również dla Draper FlexShade NEXD: Instrukcja instalacji i obsługi (6 strony), Instrukcje instalacji i obsługi (8 strony), Instrukcja obsługi (8 strony), Instrukcje instalacji i obsługi (8 strony), Instrukcje instalacji i obsługi (10 strony)
Drukuj stronę
Dual Roller FlexShade
Section 4 - Spring Assist Idler
Caution: Do not allow shade roller to become exposed by running shade fabric too far down. Use stop balls provided in
hardware packet by Draper
to set up and down travel limits. Stop balls by others may be too small, and become lodged
®
in clutch mechanism.
1.
Remove the safety screw and slide from the top
idler endcap. Retain these pieces for later.
1.
Safety
Screws
(RETAIN FOR
LATER)
3.
Swing the idler end into place, then slide the
idler end spear into the receiver. It may be
necessary to compress the spring-loaded spear.
Figure 5-C
Caution: The retaining clip must be installed around the idler-end
shaft as shown to prevent the roller assembly from moving left or
right during operation, and to ensure that the spring-loaded shaft
does not retract into the mechanism in case of a bearing failure.
NEXD
®
(Standard Hardware shown)
2.
Figure 5-A
Slide
(RETAIN FOR LATER)
Note: Retainer Clip
has extrusion to fit
into slots on shaft.
2.
Install roller assembly tube
onto clutch.
!
Tube indentation
must be aligned
with the FLAT side
of the clutch sprocket.
4.
Replace slide and
safety screw.
Place into groove
at an angle, slide
up, and ensure
the bottom of the
slide is hooked into
the receiver.
Figure 5-E
page 6 of 12
Please Note: If shade fabric is
uneven, see "Field Adjustments"
on page 2.
Figure 5-B
Figure 5-D
5.
Use the included
Adjustment Tool
in the
(C202.029)
adjustment point on
the underside of slide
to level shade.